Retiring a tired condenser
AC Installation and Replacement in Brookhaven, GA
A new system sized to your rooms and ducts, so the upstairs and downstairs finally run at the same temperature.
Retire It Only When the Math Says So
Buying new central air is a large expense, and it should not begin with a sales pitch. It should begin with the facts about the system you own. We go over how many summers the equipment has seen, what has been patched so far, how comfortable the house actually is and what the next likely repair would cost. Sometimes the right answer is one more repair. When it is time to replace, the work starts with sizing. The new unit is matched to the house, not to the label on the old one, using square footage, insulation, glass, sun exposure and the duct layout that has to distribute it. A correctly sized system with a matched indoor coil runs longer, quieter cycles and pulls more humidity out of the air, which matters through a long Brookhaven summer. Installation covers the outdoor unit, the evaporator coil, a new or cleaned refrigerant line, the condensate piping, wiring and any county or city permit and inspection the job requires. We finish with a startup test of pressures, temperatures, airflow and safeties, then haul the old equipment off so nothing is left in your yard or garage.
What a Replacement Covers
Every installation includes these steps, adjusted to the house and the equipment you choose.
Honest comparison first
How old it is, what has broken before, how the rooms feel and what it costs to run, all weighed in the open so the choice is yours.
Load-based sizing
The house is measured and the ducts are checked before a size is chosen.
Matched indoor coil
The coil and outdoor unit are paired so the efficiency rating is real, not theoretical.
Line set and drain
Copper lines swapped out or flushed clean, and the condensate piping fitted with a safety switch.
Electrical work
Disconnect box, conductors and breaker matched to what the new unit draws.
Permits and inspection
Handled where the county or city requires them for the job.
Startup testing
Charge, temperature split, airflow and safeties verified with the system running.
Haul-away
Your retired condenser and coil leave with the crew for proper disposal.
Old Unit Out, Even Comfort In
Size up the current setup
Our technician looks over the current condenser, coil, duct layout and house, then explains whether a repair or a replacement is the better use of your money.
Choose the equipment
You see the options with sizes, SEER2 ratings and prices side by side, plus any duct or electrical work the house needs.
Install and test
The crew protects the floors, installs and connects everything, pulls any permit and runs the startup checks before showing you how it all works.
Why Owners Choose Us for Replacements
Sizing, not swapping
Like-for-like replacement repeats old mistakes. We check the house first.
Ratings in context
A high SEER2 number only pays off with good ducts and a clean install. We explain both.
A tidy finish
Drop cloths inside, the retired unit carted away and the space swept before we go.
- Sized to the house
- Matched coil
- Permit paperwork covered
- Retired unit removed
Is Your Condenser Nearing Retirement?
Tell us the age of the unit and how the house has felt lately. We will help you weigh one more repair against a replacement, with prices for both.